Crafco Super Shot 125 125 GALLON MELTER APPLICATOR WITH PUMP ON DEMAND FEATURES; DIESEL FUELED A double-boiler type melter applicator that is specifically designed for and is capable of heating and applying all grades of asphalt rubber sealant, fiber modified asphalt sealant and specification joint sealant without further equipment modification. The unit has a safety shut-off feature on the lid that automatically stops the agitator when the lid is opened. The applicator wand is equipped with an automatic shut-off feature that will stop the flow of sealant when the handle is released or dropped. The heat transfer oil is heated by one 12-volt 250,000 BTU high efficiency forced air diesel fired burner directly at the bottom of the heat transfer oil tank. The burner is lit by a constant duty high voltage transformer powering an electric spark ignitor. This ignitor works in conjunction with a sensor that detects a lack of burn or ignition and shuts down the fuel supply. The thermostat control is located on the curbside of the machine for operator safety. The melter applicator has a thermostatic control device that will automatically regulate hot oil and material temperature. The temperature control will have an interlock for the agitation system, which will not allow the agitator to be activated until the material temperature reaches 275° F. The pumping system will also have an interlock, which will not allow the pump to be activated until the hose temperature reaches 325° F. The sealant material is mixed by a hydraulically driven, full sweep vertical agitator with two opposing horizontal paddles and vertical risers attached to the ends. Both the hose and wand are heated by low voltage electric current and are temperature regulated. The unit is equipped with an Isuzu diesel engine with electric start. FOB Clayco Midwest.